Vectric V-Carve Safe Z Settings TIP

Home User Forum Tips & Tricks Vectric V-Carve Safe Z Settings TIP

Tagged: , ,

This topic contains 0 replies, has 1 voice, and was last updated by  dbornyk 7 months, 1 week ago.

  • Author
    Posts
  • #1255

    dbornyk
    Participant

    Something I want to make others aware of when using the V-Carve Software for creating Pocket and Engraving Tool paths. In order to avoid issues with the Tools touching down in unwanted spots on the wood, you need to set the Z1 and Z2 and Z home heights correctly. Here’s a starting point for some reading and research. Make sure the Z Heights clear not only the Hold Down clamps, but also the wooden pieces.

    http://support.vectric.com/aspire-questions/item/how-to-use-safe-z-settings-z1-and-z2

You must be logged in to reply to this topic.